PIC18F4539T-I/ML【PDF 58/322 页】IC MCU FLASH 12KX16 EE A/D 44QFN

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录3882

54页 55页 56页 57页 [58页]59页 60页 61页 62页

PIC18FXX39

DS30485A-page 148

Preliminary

2002 Microchip Technology Inc.

16.4.5

GENERAL CALL ADDRESS

SUPPORT

The addressing procedure for the I2C bus is such that,

the first byte after the START condition usually deter-

mines which device will be the slave addressed by the

master. The exception is the general call address,

which can address all devices. When this address is

used, all devices should, in theory, respond with an

Acknowledge.

The general call address is one of eight addresses

reserved for specific purposes by the I2C protocol. It

consists of all ‘0’s with R/W = 0.

The general call address is recognized when the Gen-

eral Call Enable bit (GCEN) is enabled (SSPCON2<7>

set). Following a START bit detect, 8-bits are shifted

into the SSPSR and the address is compared against

the SSPADD. It is also compared to the general call

address and fixed in hardware.

If the general call address matches, the SSPSR is

transferred to the SSPBUF, the BF flag bit is set (eighth

bit), and on the falling edge of the ninth bit (ACK bit),

the SSPIF interrupt flag bit is set.

When the interrupt is serviced, the source for the inter-

rupt can be checked by reading the contents of the

SSPBUF. The value can be used to determine if the

address was device specific or a general call address.

In 10-bit mode, the SSPADD is required to be updated

for the second half of the address to match, and the UA

bit is set (SSPSTAT<1>). If the general call address is

sampled when the GCEN bit is set, while the slave is

configured in 10-bit Address mode, then the second

half of the address is not necessary, the UA bit will not

be set, and the slave will begin receiving data after the

Acknowledge (Figure 16-15).

FIGURE 16-15:

SLAVE MODE GENERAL CALL ADDRESS SEQUENCE

(7 OR 10-BIT ADDRESS MODE)

SDA

SCL

SSPIF

BF (SSPSTAT<0>)

SSPOV (SSPCON1<6>)

Cleared in software

SSPBUF is read

R/W = 0

ACK

General Call Address

Address is compared to General Call Address

GCEN (SSPCON2<7>)

Receiving data

ACK

after ACK, set interrupt

'0'

'1'

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式